RELE 2CH RF BROADLINK 433 MHZ RELEY RELAY 220V UNIVERSAL EN SAN CRISTÓBAL-CAPITAL FEDERA

Bienvenidos a Xnet Argentina IMPORTANTE: Consultar antes de ofertar! Atencion al gremio y mayorista. Nos encontramos en CABA: Barrio Belgrano: Cabildo y Jose Hernandez. / Subte D, estación Jose hernandez. Barrio Flores: Nazca y Avellaneda. Rele 2ch Rf Broadlink 433 Mhz Reley Relay 220v Universal RECEPTOR UNIVERSAL Rele 2ch Rf Broadlink 433 Mhz Reley relay 220v universal FUNCIONA CON CUALQUIER CONTROL REMOTO 433MHZ FUNCION AUTO APRENDIZAJE FUNCIONA A 220V DIRECTAMENTE MAS DE 100M DE ALCANCE EN ESPACIOS ABIERTOS Y OPTIMAS CONDICIONES 10A EN 220V 2200 WATTS FUNCIONA CON BROADLINK Y NO REQUIERE CONTROL REMOTO! 1-4 CH DC12V AC220V Wireless RF Remote Control Receiver Relay Switch 433MHz Rele modu RF Luces Control Remoto broadlink compatible reley 220v Note: Remote Control is not included!!! 220V 2 CH Wireless Relay Switch 1Input Voltage: AC85V-AC220V 2RF Frequency: 433MHZ 3RF Working mode:Super heterodyne receiver 4Receiver Sensitivity: -107dBm 5Remote Control Distance: 100 meter(In open environment) 6Decoding Way: MCU Software decoding 7Can store the number of remote control:32 8Support remote control type: Fixed code, learning code 9Channel: 2CH 10Multiple working modes: (Jog/Non-Latched ,inter-lock/Latched ,self-lock /Self-Latched) 11Wiring Method:Fixed wiring terminal 12Rated load:10A 250VAC / 10A 125VAC 10A 30VDC / 10A 28VDC 13Dimension:69cm*485cm*17cm Working/output way: 1Jog/Non-Latched: Press one button is Working /ON Loosen your finger on the same button is Stop/OFF One channel switch need one buttons remote control 2Self -lock/Self-Latched: Press one button for one time is working/ON Press the same button again is stop/OFF One channel switch need one buttons remote control 3Inter-lock /Latched: Press one button is working/ON, press another button is stop/OFF One channel switch need 2 buttons remote control Reset new operating mode 1 Jogging Press the white learning button on the top of the control panel, LED lights, and then press any button on the remote control set to 'Jog' button, the control panel LED lights flashing, indicating that the setup is complete 2 Self-locking Press the white learning button on the top of the control panel, LED lights, and then press any button on the remote control to set to 'self-locking' button, the control panel LED lights flashing, 3Interlock Press the white learning button on the control panel, the LED lights, and then press any button on the remote control set to 'start' button, the control panel LED lights flashing, press another button to set to 'stop' button LED Blinking means the setting is complete Gracias por elegir Xnet argnetina